Tineco iFloor Cordless Hard Floor Washer and Wet Dry Vacuum Cleaner

Tineco iFloor is versatile hard floor cleaner/washer cordless unit, allowing the user to vacuum and wash bare floors at the same time, saving time and effort.

Tineco iFloor comes with two separate tanks, lithium ion high-capacity battery, soft brushroll, self-cleaning and other features. Although it can be used even as dry vacuum only, or as carpet washer, Tineco iFloor is primarily designed for cleaning bare floors.

Published: July 29, 2019.

tineco ifloor 1

Tineco iFloor Features and Specifications

Tineco iFloor is rated at 120 watts and is powered with 22.2V 2500 mAh lithium ion battery, which is able to provide runtime of 20-22 minutes in Normal mode.

When the battery is empty, it takes around 3-4 hours to fully charge it using the charger that comes with the unit - since Tineco iFloor is powered with lithium ion battery, never charge it with the battery intended for some other unit.

Unit is charged by plugging in the charger cord into the unit and the charger into the wall, while the unit is stored in the self-cleaning storage tray.

Battery is not removable by the user - it is permanently soldered to the unit's electronics board and any issue with the battery must be resolved by the Tineco.

Unit's physical dimensions are 10.6 x 9.8 x 43.7 inches (~27 x 25 x 111 cm) and it weighs 6.5 pounds (~2.95 kg) - it is very lightweight unit, especially considering all the features that come with the unit and easy to carry around, even up and down the stairs.

Tineco iFloor features two transparent tanks, one for clean water (Clean Water Tank, CWT, 530 ml, ~18 ounces) and another for dirty liquids (Dirty Water Tank, DWT, 400 ml, ~13.5 ounces).

Water flow rate in Normal mode is ~40 ml/minute, and ~220 ml/minute in so-called Spot mode.

tineco ifloor 1a

Controls are on the handle and allow the user to easily control all the important functions of the unit.

These controls include:

- On/Off switch for turning the unit On and Off,

- Spot mode switch for cleaning tough stains and stubborn dirt. In the Spot mode brushroll spins faster and the water/cleaning solution flow is increased,

- Solution trigger which is used for releasing water/cleaning solution for cleaning floors.

Note: Tineco iFloor is intended for cleaning/washing SEALED, bare floors, like laminate, glazed ceramics, hardwood, marble and similar. Non-sealed bare floors should NOT be washed with Tineco iFloor or any similar cleaning aid. Although Tineco iFloor is easy to maintain and use washer, when it arrives, be sure to thoroughly read its manual.

Since the user controls water flow, Tineco iFloor can be also used as dry vacuum cleaner for quick cleanups, although its performances as such can't be compared with large, full size dry vacuum cleaners specifically built for such purpose.

Tineco iFloor feature main cleaner head with the soft brushroll optimized for picking up dirt off the bare floors and for washing of such surfaces.

Unit can be used as carpet washer too, but since the brushroll is soft and gentle, it can't pull out deeply embedded dirt and hair - use it for quick cleanups and for refreshing of the carpets' surfaces.

A pair of wheels, swivel neck and lightweight design ensures good maneuverability, while low main cleaner head profile help with the cleaning under and around most common floor objects and obstacles.

tineco ifloor 2

Clean Water Tank (CWT) can be filled with warm tap water (up to 140°F, 60°C) for improved cleaning - Tineco iFloor is cordless unit, and as such doesn't feature water heater.

For cleaning stubborn messes, it is recommended to add one bottle cap of Tineco's cleaning solution to the CWT.

Note: some users complain about the unit leaving floors dull and with streaks - if that happens often, try to use distilled or at least demineralized water for cleaning. Such water costs more than ordinary tap water, but it leaves no streaks and help the floors have their natural glossy shine.

Although Tineco recommends the users to use only their cleaning solution (like all other brands), the use of other cleaning solutions/formulas is possible, just be sure to follow the instructions.

Tineco iFloor Maintenance

Tineco iFloor is easy to maintain.

Battery is charged when required - unit feature battery/unit status indicator LEDs, signaling the user the state of the battery/unit.

Clean Water Tank (CWT) is filled with water or cleaning solution prior cleaning and the Dirty Water Tank (DWT) is emptied after cleaning.

Also, after cleaning it is good practice to clean, if necessary, Dirty Water Tank, safety float, and pre-filter.

Thanks to the self-cleaning storage tray, user can quickly clean the unit by placing the unit on the tray, filling the Clean Water Tank with at least 1/3 of water/cleaning solution and by pressing and holding the Start button for at least 3 seconds - this starts self-cleaning process which lasts for about 40 seconds, after which units turn itself automatically off.

Also, it is up to the user to remove tangled hair and lint from the brushroll, which can be done using ordinary scissors.

Note: for exact maintenance procedures of the Tineco iFloor check the manual.

What's in the Box?

tineco ifloor 3

When the Tineco iFloor arrives, the box contains:

- Tineco iFloor Cordless Hard Floor Washer/Wet Dry Vacuum Cleaner,

- Self-Cleaning Storage Tray,

- 3-in-1 Cleaning Tool,

- Battery Charger.

Tineco iFloor comes with 2-year limited warranty.


Long Story Short: If you are looking for a versatile unit that can be used as bare floor washer and wet dry vacuum cleaner, consider Tineco iFloor.

It has relatively good suction, gentle spinning brushroll that picks up liquids and various types of dirt, two separate tanks, self-cleaning storage tray, Normal and Spot cleaning modes, self-cleaning mode etc.

For more reviews and recommendations, check Tineco iFloor Cordless Wet Dry Vacuum Cleaner Amazon link (link opens in the new window).